How is the tension state of a linear element displayed?

 
  • Information
  • Software
    Advance Design
  • Module
    Advance Design - General
  • Version
    >2012
  • Type
    General
  • Difficulty
    *

How is the tension state of a linear element displayed?

Starting with the version 2012, Advance Design provides a new 3D way to generate and display stresses diagrams for linear elements.

As an example, we will use a frame, with a linear load of 100kN over half of the beam. We will analyze the IPE300 beam.

From the "Analysis-F.E. Results toolbar you can choose to display the stresses for the linear elements. In the following picture, the stresses diagram of the beam, is presented:

How is the tension state of a linear element displayed?

How is the tension state of a linear element displayed?

From the right click menu, you can choose the "Cross section stresses" option. This option will open the "Linear elements stresses" window, described in the following figure:

How is the tension state of a linear element displayed?

1 Section stresses diagram (2D/3D representation)
2 Stresses diagram of the linear element
3 Sectional mechanical properties
4 Specific points stresses values
5 Abscissa definition
6 Load combination and stresses type settings toolbar
7 Text font
8 Option to switch between 2D and 3D diagram
9 Option to save the content of the dialog box and insert it in a report

In the following figures the 2D and 3D stresses diagrams for a section from the middle of the beam are shown:

How is the tension state of a linear element displayed?

GRAITEC GROUP 2017 At GRAITEC we take privacy seriously. Please read our privacy policy.