Linear-elastic analysis of the structures can be performed by using one of the two methods mentioned in Eurocode 8 (EN 1998-1-1): lateral force method of analysis or modal response spectrum analysis. These methods depend on the structural characteristics of the analyzed building.
Advance Design can generate seismic action using an elastic response spectrum or a design response spectrum.
Parameters corresponding to the seism family (agr/g ; ground type, TB, TC, TD, q), for both the elastic response spectrum and the design response spectrum can be defined in the properties window (see the following figures).
For the elastic spectrum, by default, the behavior factor is "1.0" for all components of the seismic action.
For the design spectrum, the default value for the behavior factor is "1.0" for horizontal components and "1.5" for vertical component of the seismic action. The user can set other values according to the type of structural system and its regularity in elevation (see EN 1998-1, chapter 184.108.40.206 Behavior factors for horizontal seismic actions).
To set different behavior factors corresponding to the main directions of seismic action (X, Y, Z), they can be defined separately for each seismic load case (this is possible only for the elastic response spectrum, see Figure 3).
Figure 1. Elastic response spectrum
Figure 2. Design spectrum
Figure 3. Behavior factors for seismic load cases EX, EY, EZ (elastic response spectrum)
The logical diagram for determining the seismic response, when using an elastic spectrum as well as a design spectrum, is presented below
In analysis mode, by selecting any seismic load case, Advance Design will show information regarding the behavior factors used to determine seismic response (see Figure 4, for a load case corresponding to an elastic spectrum, and Figure 5, for a load case corresponding to a design spectrum).
Figure 4. Information about seismic load case EX corresponding to an elastic spectrum, in post-processing (analysis mode)
Figure 5. Information about seismic load case EX corresponding to a design spectrum, in post-processing (analysis mode)