Interface in Advance Design

 

Advance Design integrates the Advance Design RC Wall module by opening the application inside the platform.

 

To open Advance Design RC Wall module inside Advance Design, right-click on the wall (after the FEM analysis was performed) and select Open with BIM Designers.

 

 

 

 

Opening the Advance Design Wall module

 

Menu in Advance Design to open the Advance Design RC Wall module

 

 

 

 

The Advance Design RC Wall module opens, and the specific interface is loaded. The ribbon is slightly different comparing to Standalone since it is common for all elements (Footing, Beam, Column, Wall, Steel Connection) and contains not only wall specific tools but also functionalities needed by the other modules. The tools which are not specific for the wall will appear grayed out in the ribbon: Footing type, Soil Profile, Check Collisions, Foundation Sizing, Drawing Settings, Beam Bottom bars,and Beam Additional Bars (these last two can be found under Main Bars menu).

 

 

 

Interface in Advance Design

 

Advance Design RC Wall module Interface in Advance Design

 

 

Reinforcement Assumptions and Bar Constraints tools from Model ribbon in Standalone can be found when opening Reinforcement Settings dialog in Advance Design RC Wall module.

 

 

The geometry of the wall and the internal efforts are automatically exported from Advance Design. For bearing walls, internal efforts are transformed into external distributed loads, while for shear walls, the resultant forces are directly exported from Advance Design to Advance Design RC Wall module.

 

 

 

 

 

Reinforcement Settings in Advance Design Wall module

 

Reinforcement Settings in Advance Design RC Wall module

 

 

 

 

Load Cases, Combinations, and Loads tools from Model ribbon in Standalone can be found when opening Loads and Combinations dialog in Advance Design RC Wall module.

 

 

Loads and Combinations in Advance Design Wall module

 

Loads and Combinations in Advance Design RC Wall module

 

 

 

 

 

 

The Display panel from Results ribbon in Standalone can be found as a series of tabs positioned at the top of the main viewport in Advance Design RC Wall module.

 

 

Tools from Display panel in Advance Design Interface

 

Tools from Display panel in Advance Design Interface

 

 

 

 

 

The Main, Opening, Linkage tools from Rebar Cage panel in Standalone were collapsed under the same drop-down menu in Advance Design Interface, Main Bars.

 

 

 

Rebar Cage - Main Bars

 

Main Bars

 

Tools from Rebar Cage panel in Advance Design Interface

 

 

 

 

The Dimension Display Settings, Visibility Settings, and Display Settings tools from Standalone were collapsed under the same drop-down menu in Advance Design Interface, Display Settings.

 

 

Display Settings in Advance Design Interface

 

Display Settings in Advance Design Interface

 

 

 

 

Some icons in Advance Design RC Wall module may have slightly different names comparing to Standalone but they open the same dialogs. Here are the correspondences Advance Design RC Wall module - Standalone:

 

 

Some icons in Advance Design Wall module are specific for Advance Design environment and do not exist in Standalone:

 

 

 

 

 

 

 

 

 

 

 

 

Related topics