Home Graitec Forum English Forum Autodesk Advance Steel Joint Design Joint design of “base plate joint”

This topic contains 1 reply, has 2 voices, and was last updated by  Mihaela BIZDOACA 3 years, 4 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #25414

    As you will see in the attached picture, in joint design of “base plate joint” according to the EC3 code, the thickness of the base plate is taken as zero, although it is not.And also in joint design according to ASD code, a very very big plate thickness is calculated when checking against concrete bearing stress, in Case C (963.23mm plate thickness is calculated under 4.5 kNm moment, 98.4 kN axial force and 5.9 kN shear force).

    Attachment: joint design problem.jpg

    #28384

    Please install Service Pack 2 for Autodesk Advance Steel 2014 and verify again this connection

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.