GRAITEC Advantage - FAQ feed GRAITEC Advantage - FAQ feed

GRAITEC FAQ News

How is a stepped wall created with openings (holes) or using 3D solids?

  • Software:

    Autodesk Advance Concrete
  • Module

    Modeling
  • Question:

    How is a stepped wall created with openings (holes) or using 3D solids?
  • Type:

    Modeling
  • Difficulty:

    **

Answer

Using Advance Concrete, there is a variety of ways to define a stepped wall. You can choose the most intuitive and simple method. One of these methods was presented in the "How is a wall with a brick shelf designed" document. This document can be found at the following address:
http://www.graitec.com/en/FAQ_view.asp?FAQID=719

The holes method and the 3D solids method are two other methods to create stepped walls.

To create a stepped wall using the method with holes, create different adjacent openings in the cut side of the wall. For this example we will create a wall with a height of 3m, a length of 2.5m and a 30 cm thickness.

How is a stepped wall created with openings (holes) or using 3D solids

The first hole is created using the "Create a wall hole in the wall" option on the Advance Model toolbar.

How is a stepped wall created with openings (holes) or using 3D solids

The hole dimensions (R50x250) and the height of the sill (Hsill = 50 cm) are chosen from the properties window. The dimensions are set as follows: the step width of the wall is 50 cm, the height cut of the wall is 250 cm, and the height of the sill is 50 cm. Also the hole crosses through the wall thickness.

How is a stepped wall created with openings (holes) or using 3D solids

To create the second step of the wall, create a new hole or copy the first one and assign it the desired dimensions (R50x200cm and Hsil=100cm).

How is a stepped wall created with openings (holes) or using 3D solids

Create the rest of the steps in the same way:

- The third hole dimensions are: R50x150 and Hsill = 150 cm
- The forth hole dimensions are: R50x100 and Hsill = 200 cm
- The fifth hole dimensions are: R50x50 and Hsill = 250 cm

How is a stepped wall created with openings (holes) or using 3D solids

After the holes are added the stepped wall can be seen (viewed).

How is a stepped wall created with openings (holes) or using 3D solids

Another simple method to obtain the stepped wall is to create this wall using the AutoCAD solid and then transform the entity into a structural concrete element.
The "Front view" is chosen from the AutoCAD toolbar. Draw a polyline on the contour of the wall.

How is a stepped wall created with openings (holes) or using 3D solids

Choose the isometric view from the AutoCAD toolbar, and then use the "Extrude" option on the z direction. When the "extrude" command is used the thickness of the wall is defined. The polyline is transformed into an AutoCAD 3D solid .

How is a stepped wall created with openings (holes) or using 3D solids

From the Advance Model toolbar, the "3D ACIS solids to structural" option is used to transform the 3D solid into an Advance Concrete element.

How is a stepped wall created with openings (holes) or using 3D solids

How is a stepped wall created with openings (holes) or using 3D solids


The 3D solid was transformed into an Advance Concrete structural element. This method can be used for other shapes used in the modeling of the reinforced concrete structure.


Any of these simple methods can be used to achieve the stepped wall.