GRAITEC Advantage - FAQ feed GRAITEC Advantage - FAQ feed

GRAITEC FAQ News

What is the shrink option used for?

  • Software:

    Autodesk Advance Steel
  • Module

    Modeling
  • Question:

    What is the shrink option used for?
  • Type:

    Modeling
  • Difficulty:

    **

Answer

The "shrink" field is used for any kind of profile that gets longer or shorter by deformation during site assembly (e.g. pressed tubes). The length of the beam is calculated considering the "shrink" and the weight is calculated without the "shrink".

This field is in the "Beam" properties on the "Behavior" tab and represents the length of the deformations that the part will suffer on installation.

What is the shrink option used for

As an example we will consider 3 round hollow sections, each 1000 mm in length, one without a shrink, one with a positive shrink of 100mm and one with a negative shrink of 100mm. The 3 beams will be numbered and detailed in a drawing using a beam drawing style. A BOM list will be created and a BOM list on drawing will be added on the created detail drawing.

"Weight" and "Length" values in a "BOM list", "BOM list on drawing" and in the "Detail drawing":

What is the shrink option used for
What is the shrink option used for
What is the shrink option used for

The length of the beam in detail drawings and BOM lists is calculated considering the shrink value, thus the length of the single part will be the final one, with the deformations added on site to include the part in the assembly.

The weight of the beam in detail drawings and BOM lists does not consider the shrink value because the total weight of the part is the same in both cases, before and after the deformations made on site.

Note: This option does not create any kind of shorten/extend feature on the beam.